TGA801 Thermogravimetric Analysis of Moisture, Ash, Volatile Content, and Loss-on-Ignition

• Automated analysis of up to 19 samples for increased throughput.
• Automatic end point recognition based upon sample mass constancy
• Stable and precise mass measurements throughout the analysis cycle using an integrated, thermally isolated 0.0001g low drift balance
• Precise furnace temperature ramping and set point control provides excellent temperature accuracy with low temperature overshoot
• Rotating automation sequence provides uniform exposure of all samples to the furnace conditions
• Automated control of furnace atmosphere and gas flows (air, nitrogen, or oxygen)
• Flexible method settings enable configuration of system to emulate classic gravimetric test method requirements
• Furnace lid locks open preventing the uncontrolled closure of the furnace lid in the event of a power or pneumatic interruption

The TGA801 is ideal for the following applications: Coal and Coke, Combustion Residues, Biomass Materials, Catalyst Materials, Soil and Ore Materials, Ceramics, Gypsum and Building Materials, Hydrated Lime and Cement, Flour and Milled Products, Feed Materials, and Resins and Polymers.

The TGA801 Thermogravimetric Analyzer determines weight loss, including moisture, ash, volatile content, and Loss-on-Ignition (LOI), in various organic, inorganic, and synthetic materials. Weight change is measured as a function of temperature as samples are exposed to a temperature program in an atmosphere-controlled environment. The multi-sample furnace design allows for simultaneous analysis of up to 19 samples.

Analysis begins when samples have been logged in and empty crucibles have been loaded into the sample carousel. After empty crucible weights have been automatically recorded, the user is prompted to load samples. Once loaded, sample weights are recorded and the method-specified furnace-temperature program begins. One of three analytical gases (air, N2, or O2) are used to control the atmosphere inside the furnace during the course of an analysis. Temperature, temperature ramp rate, atmosphere, and duration (fixed time or mass constancy) are selectable for each method step. Moisture, volatile, and ash steps are most commonly utilized and are available as preset method steps.

The mass change of each sample is sequentially monitored throughout an analysis. Crucibles are automatically indexed to the position above (and lowered onto) the balance pedestal where sample weights are recorded. Percent mass change is typically reported at the end of each step; although alternative and additional calculations can be specified by the user in the method.

An external PC with LECO Cornerstone brand software manages all of the quantitative calculations and saves all of the data.